Manufacture and processing of cold rolled steel - 翻译中...
Cold rolled steel is steel produced by cold rolling. Cold rolling is the further thinning of No.1 steel plate to the desired thickness at room temperature. Compared with hot-rolled steel plate, cold-rolled steel plate thickness is more accurate, and the surface is smooth and beautiful, but also has a variety of superior mechanical properties, especially in terms of processing properties. Because the cold-rolled coil is brittle and hard, it is not suitable for processing, so the cold-rolled steel plate is usually required to be annealed, pickling and surface smoothing before being handed to the customer. The maximum thickness of cold rolling is below 0.1-8.0mm, such as the thickness of most cold-rolled steel plates in factories is below 4.5MM; The minimum thickness and width are determined according to the equipment capacity and market demand of each plant.
Introduction
The difference between cold rolled steel and hot rolled steel is not in the smelting process, but in the rolling temperature, or the rolling end temperature. Cold rolled steel is cold-rolled if the final rolling temperature is lower than the recrystallization temperature of the steel. Hot rolled steel is easy to roll and has high rolling efficiency, but the steel is oxidized under hot rolling conditions, and the surface of the product is dark and gray. Cold rolled steel requires large mill power, low rolling efficiency, and intermediate annealing in order to eliminate work hardening during the rolling process, so the cost is also high, but the surface of cold rolled steel is bright, good quality, and can be directly used to process finished products, so cold rolled steel is widely used.
Processing method
Hot-rolled steel coil is used as raw material, and cold continuous rolling is carried out after pickling to remove the oxide skin, and the finished product is rolled hard coil. Because of the cold hardening caused by continuous cold deformation, the strength and hardness of rolled hard coil increase, and the toughness and plastic index decrease, so the stamping performance will deteriorate, and can only be used for simple deformed parts. Rolled hard coil can be used as raw material in hot dip galvanizing plant, because hot dip galvanizing units are equipped with annealing lines. The rolled hard coil weight is generally 6~13.5 tons, and the steel coil is continuously rolled for hot rolled pickling coil at room temperature. The inner diameter is 610mm.
Why o o teteel rum rhum ung ung se se R-Type Pcosse ararrel?April 10, 2023Les barils en acier tandtandard ont un baril de prise en acier. Le joint d'étanchéité est conçu au niveau du col cylindrique du bouchon, juste sous le bord. Répétue à ces conceptions, quand le bouchon est serré, le joint peut...view
Drum Liners for Steel Drums - 翻译中...April 27, 2023Drum liners are an essential component for many industrial applications that require the transportation or storage of liquid or powdered materials. When it comes to steel drums, drum liners are partic...view
55-Gallon Steel Drum - 翻译中...May 12, 2023In life, we often hear the term "55-gallon drum". So where does this number come from? In fact, the 55-gallon drum is a commonly used liquid storage container with a capacity of 55 American ...view